Users Guide

6 0% ETS
7 0% ETS
Priority# Bandwidth TSA
0 13% ETS
1 13% ETS
2 13% ETS
3 13% ETS
4 12% ETS
5 12% ETS
6 12% ETS
7 12% ETS
Remote Parameters:
-------------------
Remote is disabled
Local Parameters :
------------------
Local is enabled
TC-grp Priority# Bandwidth TSA
0 0,1,2,3,4,5,6,7 100% ETS
1 0% ETS
2 0% ETS
3 0% ETS
4 0% ETS
5 0% ETS
6 0% ETS
7 0% ETS
Priority# Bandwidth TSA
0 13% ETS
1 13% ETS
2 13% ETS
3 13% ETS
4 12% ETS
5 12% ETS
6 12% ETS
7 12% ETS
Oper status is init
Conf TLV Tx Status is disabled
Traffic Class TLV Tx Status is disabled
0 Input Conf TLV Pkts, 0 Output Conf TLV Pkts, 0 Error Conf TLV Pkts
0 Input Traffic Class TLV Pkts, 0 Output Traffic Class TLV Pkts, 0 Error Traffic Class TLV Pkts
The following table describes the show interface ets detail command elds.
Table 22.
show interface ets detail Command Description
Field Description
Interface Interface type with and port number.
Maximum Supported Maximum number of priority groups supported.
Number of Trac Classes Number of 802.1p priorities currently congured.
Admin mode ETS mode: on or o.
Admin Parameters ETS conguration on local port, including priority groups, assigned
dot1p priorities, and bandwidth allocation.
Remote Parameters ETS conguration on remote peer port, including Admin mode
(enabled if a valid TLV was received or disabled), priority groups,
assigned dot1p priorities, and bandwidth allocation. If the ETS
Admin mode is enabled on the remote port for DCBx exchange, the
Willing bit received in ETS TLVs from the remote peer is included.
Data Center Bridging (DCB) 279