Users Guide

• Management Interfaces
• Adjusting the Keepalive Timer
• Clearing Interface Counters
Overview of Layer Modes
On all systems running Dell Networking OS, you can place physical interfaces, port channels, and VLANs in Layer 2 mode or Layer 3 mode.
By default, VLANs are in Layer 2 mode.
Table 38. Layer Modes
Type of Interface Possible Modes Requires Creation Default State
10 Gigabit Ethernet, 25–Gigabit
Ethernet, 40–Gigabit Ethernet,
50–Gigabit Ethernet, and 100–
Gigabit Ethernet.
Layer 2
Layer 3
No Shutdown (disabled)
Management N/A No Shutdown (disabled)
Loopback Layer 3 Yes No shutdown (enabled)
Null interface N/A No Enabled
Port Channel
Layer 2
Layer 3
Yes Shutdown (disabled)
VLAN
Layer 2
Layer 3
Yes, except for the default
VLAN.
No shutdown (active for Layer
2)
Shutdown (disabled for Layer 3 )
Conguring Layer 2 (Data Link) Mode
Do not congure switching or Layer 2 protocols such as spanning tree protocol (STP) on an interface unless the interface has been set to
Layer 2 mode.
To set Layer 2 data transmissions through an individual interface, use the following command.
• Enable Layer 2 data transmissions through an individual interface.
INTERFACE mode
switchport
Example of a Basic Layer 2 Interface Conguration
Dell(conf-if)#show config
!
interface Port-channel 1
no ip address
switchport
no shutdown
Dell(conf-if)#
Interfaces
377