Users Guide

The physical port is missing from the show inventory media command output:
Dell# show inventory media
Slot Port Type Media Serial Number Dell Qualified
-----------------------------------------------------------------------------------
1 3/1/1 QSFP 40GBASE-SR4 4829455N01XP Yes
1 3/1/2 QSFP 40GBASE-SR4 4829455N01XP Yes
1 3/1/3 QSFP 40GBASE-SR4 4829455N01XP Yes
1 3/1/4 QSFP 40GBASE-SR4 4829455N01XP Yes
The physical port is missing also from the show ip interface brief command output:
Dell# show ip interface brief
TenGigabitEthernet 1/3/1/1 unassigned YES Manual up up
TenGigabitEthernet 1/3/1/2 unassigned NO Manual administratively down down
TenGigabitEthernet 1/3/1/3 unassigned NO Manual administratively down down
TenGigabitEthernet 1/3/1/4 unassigned NO Manual administratively down down
TenGigabitEthernet 1/3/3/1 unassigned NO Manual administratively down down
TenGigabitEthernet 1/3/3/2 unassigned NO Manual administratively down down
TenGigabitEthernet 1/3/3/3 unassigned NO Manual up down
TenGigabitEthernet 1/3/3/4 unassigned NO Manual administratively down down
Splitting 100G Ports
The platform supports splitting a single 100G QSFP 28 port into any of the following ports:
• Two 50G ports
• Four 25G ports
• One 40G port
• Four 10G ports
NOTE
: You can use the supported breakout cables (for a list of supported cables, refer to the Installation Guide or the Release
Notes).
To split a single 100G port into 50G, 25G, 40G, and 10G ports, use the following commands:
• Split a 100G port into two 50G ports.
CONFIGURATION Mode
stack-unit stack-unit-number module module-number port number portmode dual speed 50G
• stack-unit-number: enter the stack member unit identier of the stack member to reset.
• module module-number: enter the keyword module then the module number to specify the optional module in which the port is
present.
• number: enter the port number of the 100G port to be split. The range is from 1 to 8.
• Split a 100G port into four 25G ports.
CONFIGURATION Mode
stack-unit stack-unit-number module module-number port number portmode quad speed 25G
• stack-unit-number: enter the stack member unit identier of the stack member to reset.
• module module-number: enter the keyword module then the module number to specify the optional module in which the port is
present.
• number: enter the port number of the 100G port to be split. The range is from 1 to 8.
• Split a 100G port into one 40G ports.
CONFIGURATION Mode
stack-unit stack-unit-number module module-number port number portmode single speed 40G
• stack-unit-number: enter the stack member unit identier of the stack member to reset.
Interfaces
397