Users Guide

Remote MTU: 1554
Remote System Desc: Dell Networks Real Time Operating System Software
Dell Operating System Version: 1.0.
Dell Application Software Version: 9.8(1.0). Copyright (c) 1999-2014
Build Time: Thu Aug 9 01:05:51 PDT 1999-2015
Existing System Capabilities: Repeater Bridge Router
Enabled System Capabilities: Repeater Bridge Router
Remote Port Vlan ID: 1
Port and Protocol Vlan ID: 1, Capability: Supported, Status: Enabled
---------------------------------------------------------------------------
========================================================================
Conguring LLDPDU Intervals
LLDPDUs are transmitted periodically; the default interval is 30 seconds.
To congure LLDPDU intervals, use the following command.
• Congure a non-default transmit interval.
CONFIGURATION mode or INTERFACE mode
hello
Example of Viewing LLDPDU Intervals
R1(conf)#protocol lldp
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
no disable
R1(conf-lldp)#mode ?
rx Rx only
tx Tx only
R1(conf-lldp)#
mode tx
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
mode tx
no disable
R1(conf-lldp)#
no mode
R1(conf-lldp)#show config
!
protocol lldp
advertise dot1-tlv port-protocol-vlan-id port-vlan-id
advertise dot3-tlv max-frame-size
advertise management-tlv system-capabilities system-description
no disable
R1(conf-lldp)#
Conguring Transmit and Receive Mode
After you enable LLDP, the system transmits and receives LLDPDUs by default.
To congure the system to transmit or receive only and return to the default, use the following commands.
• Transmit only.
CONFIGURATION mode or INTERFACE mode
mode tx
Link Layer Discovery Protocol (LLDP)
523