Users Guide

• Estimated CAM — the estimated number of CAM entries that the policy will consume when it is applied to an interface.
• Status — indicates whether the specied policy-map can be completely applied to an interface in the port-pipe.
• Allowed — indicates that the policy-map can be applied because the estimated number of CAM entries is less or equal to the
available number of CAM entries. The number of interfaces in the port-pipe to which the policy-map can be applied is given in
parentheses.
• Exception — indicates that the number of CAM entries required to write the policy-map to the CAM is greater than the number of
available CAM entries, and therefore the policy-map cannot be applied to an interface in the specied port-pipe.
NOTE: The show cam-usage command provides much of the same information as the test cam-usage command, but
whether a policy-map can be successfully applied to an interface cannot be determined without rst measuring how many CAM
entries the policy-map would consume; the test cam-usage command is useful because it provides this measurement.
• Verify that there are enough available CAM entries.
test cam-usage
Example of the test cam-usage Command
Dell# test cam-usage service-policy input pmap_l2 port-set 0 | port pipe
Port-pipe | CAM Partition | Available CAM | Estimated CAM | Status
=====================================================================
0 L2ACL 500 200 Allowed(2)
Specifying Policy-Based Rate Shaping in Packets Per
Second
You can congure the rate shaping in packets per second (pps) for QoS output policies.
You can congure rate shaping in pps for a QoS output policy, apart from specifying the rate shaping value in bytes. You can also congure
the peak rate and the committed rate for packets in kilobits per second (Kbps) or pps.
Committed rate refers to the guaranteed bandwidth for trac entering or leaving the interface under normal network conditions. When
trac propagates at an average rate that is less than or equal to the committed rate, it is considered to be green-colored or coded. When
the transmitted trac falls below the committed rate, the bandwidth, which is not used by any trac that is traversing the network, is
aggregated to form the committed burst size. Trac is considered to be green-colored up to the point at which the unused bandwidth
does not exceed the committed burst size.
Peak rate refers to the maximum rate for trac arriving or exiting an interface under normal trac conditions. Peak burst size indicates the
maximum size of unused peak bandwidth that is aggregated. This aggregated bandwidth enables brief durations of burst trac that
exceeds the peak rate and committed burst.
In releases of Dell Networking OS earlier than Release 9.3(0.0), you can congure only the maximum shaping attributes, such as the peak
rate and the peak burst settings. You can now specify the committed or minimum burst and committed rate attributes. The committed
burst and committed rate values can be dened either in bytes or pps.
You can use the rate-shape pps peak-rate burst-packets command in the QoS Policy Out Conguration mode to congure
the peak rate and burst size as a measure of pps. Alternatively, you can use the rate shape kbps peak-rate burst-KB command
to congure the peak rate and peak burst size as a measure of bytes.
Similarly, you can use the rate-shape pps peak-rate burst-packets committed pps committed-rate burst-
packets command in the QoS Policy Out Conguration mode to congure the committed rate and committed burst size as a measure of
pps. Alternatively, you can use the
rate shape kbps peak-rate burst-KB committed kbps committed-rate burst-
KB command to congure the committed rate and committed burst size as a measure of bytes. If you congure the peak rate in pps, the
peak burst size must also be congured as a measure of number of packets. Similarly, if you congure the peak rate in Kbps, the peak burst
size must also be congured as a measure of bytes.
Quality of Service (QoS)
717