Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S6100-ON

1141

ip pim rp-candidate

Configure a PIM router to send out a Candidate-RP-Advertisement message to the bootstrap (BS) router or define group prefixes that

are defined with the RP address to PIM BSR.

Syntax

ip pim [vrf vrf-name] rp-candidate {interface [priority] [acl-name]}

To return to the default value, use the no ip pim [vrf vrf-name] rp-candidate {interface

[priority]} command.

Parameters

vrf

vrf-name

(OPTIONAL) Enter the keyword vrf followed by the name of the VRF.

NOTE: Applies to specific VRF if input is provided, else applies to Default

VRF.

interface

Enter the following keywords and slot/port or number information:

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then

the stack/slot/port/subport information.

• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the

stack/slot/port/subport information.

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/

slot/port[/subport] information.

• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/

slot/port/subport information.

• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the

stack/slot/port information.

• For a Loopback interface, enter the keyword loopback then a number from 0 to

16383.

• For a port-channel interface, enter the keywords port-channel then the port-

channel ID.

• For a VLAN, enter the keyword vlan then a number from 1 to 4094.

priority

(OPTIONAL) Enter the priority used in Bootstrap election process. The range is zero (0)

to 255. The default is 192.

acl-name

(OPTIONAL) Enter the name of an ACL to configure a PIM router to act as an RP for a

specific set of multicast group addresses that are defined in the ACL.

Defaults Not configured.

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.11(0.0) Introduced the acl-name parameter.

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100-ON.

9.8(1.0) Introduced on the Z9100-ON.

9.7(0.0) Added support for VRF. Introduced on the S6000-ON.

9.5(0.1) Introduced on the Z9500.

9.0.2.0 Introduced on the S6000.

8.3.19.0 Introduced on the S4820T.

8.3.11.1 Introduced on the Z9000.

8.3.7.0 Introduced on the S4810.

1142 PIM-Sparse Mode (PIM-SM)