Administrator Guide
Version Description
7.7.1.0 Added the DSCP Marking option support on the S-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series; added support for the DSCP Marking option.
6.1.1.1 Introduced on the E-Series.
Usage Information To access this command, enter the class-map command. After the class map is identified, you can configure
the match criteria. For class-map match-any, a maximum of five ACL match criteria are allowed. For class-map
match-all, only one ACL match criteria is allowed.
Related
Commands
• class-map — identifies the class map.
match ip dscp
Use a differentiated services code point (DSCP) value as a match criteria.
Syntax
[seq sequence number] match {ip | ipv6 | ip-any} dscp dscp-list [set-ip-dscp
value]
To remove a DSCP value as a match criteria, use the no [seq sequence number] match {ip | ipv6
| ip-any} dscp dscp-list [[multicast] set-ip-dscp value] command.
Parameters
seq
sequence
number
(OPTIONAL) Enter the keyword seq then the sequence number. The range is from 1 to
100. By default, the sequence number are assigned in multiples of five.
ip Enter the keyword ip to support IPv4 traffic.
ipv6 Enter the keyword ipv6 to support IPv6 traffic.
ip-any Enter the keyword ip-any to support IPv4 and IPv6 traffic.
dscp-list
Enter the IP DSCP values that is to be the match criteria. Separate values by commas —
no spaces ( 1,2,3 ) or indicate a list of values separated by a hyphen (1-3). The range is
from 0 to 63.
set-ip-dscp
value
(OPTIONAL) Enter the keywords set-ip-dscp then the IP DSCP value. The matched
traffic is marked with the DSCP value. The range is from 0 to 63.
Defaults none
Command Modes CLASS-MAP CONFIGURATION (config-class-map)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.12(0.0) Introduced the seq option for the class-map on all the Dell EMC Networking OS
platforms.
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
1210 Quality of Service (QoS)