Administrator Guide

• logging console — set the logging console parameters.
• logging monitor — set the logging parameters for the terminal connections.
logging source-interface
Specify that the IP address of an interface is the source IP address of Syslog packets sent to the Syslog server.
Syntax
logging source-interface interface
To disable this command and return to the default setting, use the no logging source-interface
command.
Parameters
interface Enter the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For the Management interface, enter the keyword ManagementEthernet then the
slot/port information.
• For a port-channel interface, enter the keywords port-channel then the port-
channel ID.
• For a Null interface, enter the keyword null then the Null interface number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.2(0.0) Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
1458 Simple Network Management Protocol (SNMP) and Syslog