Administrator Guide
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the E-Series (IPv6).
8.1.1.0 Introduced on the E-Series (IPv4).
7.8.1.0 Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up
to 16 characters long.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information
When you have exhausted all the sequence numbers, this feature permits re-assigning a new sequence number to
entries of an existing access-list.
seq
Assign a sequence number to a deny or permit filter in an IP access list while creating the filter.
Syntax
seq sequence-number {deny | permit} {source [mask] | any | host ip-address}}
[count [byte] | log] [dscp value] [ecn value] [fragments] [monitor] [no-drop]
[order]
To delete a filter, use the no seq sequence-number command.
Parameters
sequence-number
Enter a number from 0 to 4294967290.
deny Enter the keyword deny to configure a filter to drop packets meeting this condition.
permit Enter the keyword permit to configure a filter to forward packets meeting this criteria.
source
Enter an IP address in dotted decimal format of the network from which the packet was
received.
mask
(OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when
specified in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host
ip-address
Enter the keyword host then the IP address to specify a host IP address or hostname.
count (OPTIONAL) Enter the keyword count to count packets the filter processes.
bytes (OPTIONAL) Enter the keyword bytes to count bytes the filter processes.
log (OPTIONAL) Enter the keyword log to enter ACL matches in the log.
192 Access Control Lists (ACL)