Administrator Guide

• When the interface range prompt has multiple port ranges, the smaller port range is excluded from the
prompt.
• If overlapping port ranges are specified, the port range is extended to the smallest start port and the biggest
end port.
• The interface range format for a 10G interface is stack/slot/port/subport.
• The interface range format for a 25GG interface is stack/slot/port/subport.
• The interface range format for a 40G interface is stack/slot/port[/subport].
• The interface range format for a 50G interface is stack/slot/port/subport.
• The interface range format for a 100G interface is stack/slot/port.
Example (If atleast
one port is
configured)
DellEMC(conf)# interface range tengigbitethernet 1/1/1/1 - 1/1/2/4,
fortyGigE 1/5/1, tengigbitethernet 1/1/3/1
% Warning: Non-existing ports (not configured) are ignored by
interface-range
DellEMC(conf)# interface range fortyGigE 1/10/1 - 1/12/4, HundredGigE 1/13,
fortyGigE 1/15/1
% Warning: Non-existing ports (not configured) are ignored by
interface-range
Example (If no
ports are
configured within
the specified
interface range)
DellEMC(conf)# interface range tengigbitethernet 1/1/1/1 - 1/1/2/4,
fortyGigE 1/5/1, tengigbitethernet 1/1/3/1
% Error: No port is configured in interface range
DellEMC(conf)# interface range fortyGigE 1/10/1 - 1/12/4, HundredGigE 1/13,
fortyGigE 1/15/1
% Error: No port is configured in interface range
Example
(Configuration
Terminal Batch
Mode)
DellEMC(conf-b)#interface range te 1/1-4
DellEMC(conf-if-range-te-1/1-4)#
DellEMC(conf-b)#interface range te 1/1-4
DellEMC(conf-if-range-te-1/1-4)#
Example (Multiple
Ports)
DellEMC(conf)# interface range tengigabitethernet 1/1/1/1 - 1/1/4/3,
tengigabitethernet 1/1/3/2 - 1/1/4/1
DellEMC(conf-if-range-te-1/1/1/1-1/1/4/3)#
Example
(Overlapping
Ports)
DellEMC(conf)# interface range tengigabitethernet 1/1/1/1 - 1/1/3/1,
tengigabitethernet 1/1/1/1 - 1/1/4/3
DellEMC(conf-if-range-te-1/1/1/1-1/1/4/3)#
Usage Information
Only VLAN and port-channel interfaces created using the interface vlan and interface port-
channel commands can be used in the interface range command.
Use the show running-config command to display the VLAN and port-channel interfaces. VLAN or port-
channel interfaces that are not displayed in the show running-config command cannot be used with the
bulk configuration feature of the interface range command. You cannot create virtual interfaces (VLAN,
Port-channel) using the interface range command.
NOTE: If a range has VLAN, physical and port-channel interfaces, only commands related to
physical interfaces can be bulk configured. To configure commands specific to VLAN and port-
channel only those respective interfaces should be configured in a particular range.
Interfaces 651