Administrator Guide

Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added support for forty gigabit, vlan, and tengigabit ethernet interfaces. Introduced on
the S6000-ON.
9.0.2.0 Introduced on the S6000.
9.0.0.0 Introduced on the Z9000 and added support for IPv6.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information When a static route (or a protocol route) overlaps with Management static route, the static route (or a protocol
route) is preferred over the Management Static route. Also, Management static routes and the Management
Connected prefix are not reflected in the hardware routing tables. Separate routing tables are maintained for IPv4
and IPv6 management routes. This command manages both tables.
Related
Commands
• interface ManagementEthernet — configure the Management port on the system (either the Primary or
Standby RPM).
• speed (Management interface) — set the speed for the Management interface.
show arp
Display the ARP table.
Syntax
show arp [vrf vrf-name] [interface interface | ip ip-address [mask] |
macaddress mac-address [mac-address mask]] [retries] [static | dynamic]
[inspection {database | statistics][summary]
Parameters
vrf vrf-name (OPTIONAL) Enter the keyword vrf and then the name of the VRF.
NOTE: Use this attribute to start a BGP instance for either a specific
address family corresponding to the default VRF or an IPv4 address family
corresponding to a non-default VRF.
interface interface (OPTIONAL) Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
IPv4 Routing 745