Administrator Guide

destination-ip
address
Enter the keywords destination-ip then the IP destination address in IP address
format.
protocol number
[tcp | udp]
Enter the keyword protocol then one of the protocol type keywords: tcp, udp, or
protocol number The protocol number range is from 0 to 255. .
src-port number Enter the keywords src-port then the source port number.
destination-port
number
Enter the keywords destination-port then the destination port number.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100–ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.10.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
8.1.1.0 Introduced on the E-Series.
7.9.1.0 Introduced VRF on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.1.1.0 Introduced on the E-Series.
Usage Information
This command provides egress port information for a given IP flow. This information is useful in identifying which
interface the packet follows in the case of Port-channel and Equal Cost Multi Paths. Use this command for routed
packed only. For switched packets, use the show port-channel-flow command.
The show ip flow command does not compute the egress port information when load-balance mac
hashing is also configured due to insufficient information (the egress MAC is not available).
S-Series produces the following error message: %Error: Unable to read IP route table.
Example
DellEMC# show ip flow interface te 1/1/4/1 20.1.1.1 100.1.1.2 protocol tcp
Flow: 20.1.1.1 100.1.1.2 6
Ingress interface: Te 1/1/4/1
Egress Interface: Te 1/1/5/1
DellEMC#
754 IPv4 Routing