Users Guide

Version Description
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
pre-6.2.1.1 Introduced on the E-Series.
Related Commands
• line — applies an authentication method list to the designated terminal lines.
• ip access-list standard — names (or selects) a standard access list to lter based on the IP address.
• ip access-list extended — names (or selects) an extended access list based on the IP addresses or protocols.
enable password
Change the password for the enable command.
Syntax
enable password [level level] [encryption-type] password
To delete a password, use the no enable password [encryption-type] password [level
level] command.
Parameters
level level (OPTIONAL) Enter the keyword level then a number as the level of access. The range
is from 1 to 15.
encryption-type
(OPTIONAL) Enter the number 7 or 0 as the encryption type.
Enter a 7 then a text string as the hidden password. The text string must be a password
that was already encrypted by a Dell Networking router.
Use this parameter only with a password that you copied from the show running-
config le of another Dell Networking router.
password Enter a text string, up to 32 characters long, as the clear text password.
Defaults No password is congured. level = 15.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
Security 1349