Users Guide
Usage Information You can assign one ingress ACL and one egress ACL to an interface.
NOTE: If you apply outbound(egress) IP acl on a switch port, the lter applies only for routed trac
egressing out of that port.
To associate an access-list to a non-default VRF, use the vrf attribute of this command. You can use this
command at the interface context (physical/LAG) to apply the access-list to a range of VRFs.
The VRF MODE is not available for the default and management VRFs.
Related Commands
• ip access-list standard — congure a standard ACL.
• ip access-list extended — congure an extended ACL.
ip control-plane egress-lter
Enable egress Layer 3 ACL lookup for IPv4 CPU trac.
Syntax
ip control-plane egress-filter
Defaults Not enabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
show ip accounting access-list
Display the IP access-lists created on the switch and the sequence of lters.
Syntax
show ip accounting access-list [access-list-name [cam-count | interface
interface [cam_count] | vrf {management | vrf-name}[cam_count] {in | out}]
Parameters
access-list-name Enter the name of the ACL to be displayed.
Access Control Lists (ACL) 185