Users Guide

• Use the no deny icmp {source mask | any | host ip-address} {destination mask |
any | host ip-address} command.
Parameters
source Enter the IP address of the network or host from which the packets were sent.
mask Enter a network mask in /prex format (/x) or A.B.C.D. The mask, when specied in
A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the lter.
host ip-address Enter the keyword host then the IP address to specify a host IP address.
destination Enter the IP address of the network or host to which the packets are sent.
dscp Enter this keyword dscp to deny a packet based on the DSCP value. The range is from 0
to 63.
count (OPTIONAL) Enter the keyword count to count packets processed by the lter.
byte (OPTIONAL) Enter the keyword byte to count bytes processed by the lter.
order (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry.
The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower
order numbers have a higher priority) If you did not use the keyword order, the ACLs
have the lowest order by default (255).
fragments Enter the keyword fragments to use ACLs to control packet fragments.
monitor (OPTIONAL) Enter the keyword monitor then the session–ID to describe the trac
that you want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface. The session–ID range is from 0 to 65535. For more information, see
Flow-based Monitoring in the Port Monitoring section in the Dell Networking OS
Conguration Guide.
no-drop Enter the keywords no-drop to match only the forwarded packets.
Defaults Not congured.
Command Modes CONFIGURATION-EXTENDED-ACCESS-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.8(0.0) Added the no-drop parameter.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
Access Control Lists (ACL) 197