Users Guide
Version Description
7.4.1.0 Introduced on the E-Series.
Usage Information The number of entries allowed per ACL is hardware-dependent. For detailed specication on entries allowed per
ACL, refer to your line card documentation. You can create an IPv6 ACL for control-plane trac policing for
OSPFv3, in addition to the CoPP support for VRRP, BGP, and ICMP.
permit
To congure a lter that matches the lter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or UDP.
Syntax
permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp}
To remove this lter, you have two choices:
• Use the no seq sequence-number command syntax if you know the lter’s sequence number
• Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} command
Parameters
ip-protocol-number Enter an IPv6 protocol number. The range is from 0 to 255.
icmp Enter the keyword icmp to lter internet Control Message Protocol version 6.
ipv6 Enter the keyword ipv6 to lter any internet Protocol version 6.
tcp Enter the keyword tcp to lter the Transmission Control protocol.
udp Enter the keyword udp to lter the User Datagram Protocol.
Defaults Not congured.
Command Modes ACCESS-LIST
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
222 Access Control Lists (ACL)