Users Guide

To disable dmzlink-dw for the peer group, use the no neighbor ip-address dmzlink-dw command.
Parameters
ip-address Enter the IP address of the router to be included in the peer group.
peer-group-name Enter the name of a congured peer group.
dmzlink-bw Enter the keyword dmzlink-bw to attach a link bandwidth to received routes.
NOTE: If dmzlink-bw is congured for a peer, in order for the BGP peer to
advertise the prexes with dmzlink-bw attached to it, you must reset the the
peer or peer-group using the clear ip bgp session command.
Defaults Not congured.
Command Modes ROUTER BGP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100-ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Added the dmzlink-bw parameter.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.8.1.0 Introduced on the S-Series.
7.7.1.0 Introduced on the C-Series.
Usage Information
You can assign up to 256 peers to one peer group.
When you add a peer to a peer group, it inherits all the peer group’s congured parameters. A peer cannot become
part of a peer group if any of the following commands are congured on the peer:
• neighbor advertisement-interval
• neighbor distribute-list
• neighbor route-map
• neighbor route-reector-client
if a neighbor’s conguration is more specic than its peer group’s conguration, the neighbor may retain its
conguration after it is added to the peer group. The neighbor’s conguration does not aect outgoing updates.
A peer group must exist (be enabled) before you add a peer to it. If the peer group is disabled (shutdown), the
peers within that group are also disabled (shutdown).
370 Border Gateway Protocol