Users Guide

cam-acl (Conguration)
Select the default CAM allocation settings or recongure a new CAM allocation for Layer 2, IPv4, and IPv6 ACLs, Layer 2 and Layer 3
(IPv4) QoS, Layer 2 Protocol Tunneling (L2PT), IP and MAC source address validation for DHCP, Ethernet Connectivity Fault Management
(CFM) ACLs, OpenFlow, and Policy-based Routing (PBR).
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number
l2qos number l2pt number ipmacacl number vman-qos | vman-dual-qos number
[etsacl number] [fcoe number][fedgovacl number] [nlbclusteracl number] [ipv4pbr
number] [openflow number] [vrfv4acl number] [ipv4udfenable] [ipv4udfmirracl
number]
Parameters
default Use the default CAM prole settings and set the CAM as follows:
• L2Acl : 2
• Ipv4Acl : 2
• Ipv6Acl : 0
• Ipv4Qos : 2
• L2Qos : 2
• L2PT : 0
• IpMacAcl : 1
• VmanQos : 0
• EtsAcl : 0
• FcoeAcl : 0
• ipv4pbr : 0
• vrfv4Acl : 0
• Openow : 0
• fedgovacl : 0
• nlbclusteracl: 0
• ipv4udfmirracl: 0
l2acl number Enter the keyword l2acl and then the number of l2acl blocks. The range is from 0 to 8
in multiples of 2.
ipv4acl number Enter the keyword ipv4acl and then the number of FP blocks for IPv4. The range is
from 0 to 9 in multiples of 3, when ipv4udfenable is selected. If not enabled, it is in
multiples of 2.
ipv6acl number Enter the keyword ipv6acl and then the number of FP blocks for IPv6. The range is
from 0 to 9 in multiples of 3.
ipv4qos number Enter the keyword ipv4qos and then the number of FP blocks for IPv4. The range is
from 0 to 8 in multiples of 2.
l2qos number Enter the keyword l2qos and then the number of FP blocks for l2 qos. The range is from
0 to 8 in multiples of 2.
l2pt number Enter the keyword l2pt and then the number of FP blocks for l2 protocol tunnelling. The
range is from 0 to 8 in multiples of 2.
430 Content Addressable Memory (CAM)