Users Guide

• ets-conf: enables the advertisement of ETS conguration TLVs.
• ets-reco: enables the advertisement of ETS recommend TLVs.
• pfc: enables the advertisement of PFC TLVs.
Defaults All PFC and ETS TLVs are advertised.
Command Modes PROTOCOL LLDP
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100.
9.8(1.0) Introduced on the Z9100–ON.
9.7(0.0) Introduced on the S6000-ON and Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.12.0 Introduced on the S4810.
8.3.16.0 Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
You can congure the transmission of more than one TLV type at a time; for example: advertise dcbx-tlv
ets-conf ets-reco.
You can enable ETS recommend TLVs (ets-reco) only if you enable ETS conguration TLVs (ets-conf). To
disable TLV transmission, use the no form of the command; for example, no advertise dcbx-tlv pfc
ets-reco
.
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Congure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX
conguration on a port, use the show interface dcbx detail command.
dcbx port-role
Congure the DCBX port role the interface uses to exchange DCB information.
Syntax
dcbx port-role {config-source | auto-downstream | auto-upstream | manual}
To remove DCBX port role, use the no dcbx port-role {config-source | auto-downstream |
auto-upstream | manual} command.
Parameters
cong-source |
auto-downstream |
auto-upstream |
manual
Enter the DCBX port role, where:
• config-source: congures the port to serve as the conguration source on the
switch.
• auto-upstream: congures the port to receive a peer conguration. The
conguration source is elected from auto-upstream ports.
460 Data Center Bridging (DCB)