Users Guide

Parameters
desc_text Enter a text string up to 240 characters long.
Defaults None
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Modied for E-Series: Revised from 78 to 240 characters.
Usage Information
Important Points to Remember:
• To use special characters as a part of the description string, you must enclose the whole string in double
quotes.
• Spaces between characters are not preserved after entering this command unless you enclose the entire
description in quotation marks (“desc_text”).
•
Entering a text string after the description command overwrites any previous text string that you
previously congured as the description.
• The shutdown and description commands are the only commands that you can congure on an interface
that is a member of a port-channel.
• Use the show interfaces description command to display descriptions congured for each interface.
default interface
Reset a physical interface to its factory default settings.
Syntax
default interface interface-type slot/port - range
Parameters
interface-type slot/
port[/subport]
Enter the interface type and slot/port [/subport] information:
Interfaces 635