Users Guide

1/3 Quad 10G
1/5 Quad 10G
1/7 Quad 10G
1/9 Quad 10G
1/11 Quad 10G
1/13 Quad 10G
1/15 Quad 10G
2/1 Quad 10G
2/3 Quad 10G
2/5 Quad 10G
2/7 Quad 10G
2/9 Quad 10G
2/11 Quad 10G
2/13 Quad 10G
2/15 Quad 10G
show interfaces switchport
Display only virtual and physical interfaces in Layer 2 mode. This command displays the Layer 2 mode interfaces’ IEEE 802.1Q tag status
and VLAN membership.
Syntax
show interfaces switchport [interface-type | stack-unit unit-id ]
Parameters
interface-type (OPTIONAL) Enter one of the following keywords and the interface information:
• For a port channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the
stack/slot/port/subport information.
•
For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a backup interface for this interface, enter the keyword backup.
NOTE: This command also enables you to view information corresponding to a
range of ports.
• For physical interfaces, you can specify multiple ports as slot/port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1 - 4.
• For port–channel interfaces, you can specify multiple ports as port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as
show interfaces port—channel 1 - 4.
stack-unit
unit-id (OPTIONAL) Enter the keywords stack-unit then the stack member number.
Command Modes
• EXEC
• EXEC Privilege
Interfaces 679