Users Guide

Vlan 2
Name: TenGigabitEthernet 1/1/3/1
802.1QTagged: True
Vlan membership:
Vlan 2
Name: TenGigabitEthernet 1/1/4/1
802.1QTagged: True
Vlan membership:
Vlan 2
--More--
Related Commands
• interface — congure a physical interface on the switch.
• show ip interface — display Layer 3 information about the interfaces.
• show interfaces transceiver — display the physical status and operational status of an installed transceiver. The
output also displays the transceiver’s serial number.
show interfaces transceiver
Display the details of an installed transceiver.
Syntax
show interfaces [interface number] transceiver
Parameters
interfaces interface
number
(OPTIONAL) Enter one of the following keywords and then the interface information:
• For a port channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the
stack/slot/port/subport information.
•
For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
NOTE: This command also enables you to view information corresponding to a
range of ports. However, for Open Networking (ON) platforms the notation
for specifying port range in the command is dierent from how you specify in
non-ON platforms.
• For non-ON platforms, you can specify multiple ports as slot/port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport] -
slot/port/[subport]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as
show
interfaces interface-type 1/1/1 - 1/1/4.
Command Modes
• EXEC
• EXEC Privilege
Interfaces 681