Users Guide
• interface port-channel — create a Port Channel interface.
• shutdown — disable/enable the port channel.
group
Group two LAGs in a supergroup (“fate-sharing group” or “failover group”).
Syntax
group group_number port-channel number port-channel number
To remove an existing LAG supergroup, use the no group group_number command.
Parameters
group_number Enter an integer from 1 to 32 that uniquely identies this LAG fate-sharing group.
port-channel
number
Enter the keywords port-channel then an existing LAG number. Enter this keyword/
variable combination twice, identifying the two paired LAGs.
Defaults None
Command Modes PORT-CHANNEL FAILOVER-GROUP (conf-po-failover-grp)
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the C-Series, E-Series, and S-Series.
Related Commands
• port-channel failover-group — access PORT-CHANNEL FAILOVER-GROUP mode to congure a LAG failover
group.
• show interfaces port-channel — display information on congured Port Channel groups.
696 Interfaces