Users Guide

If the line card is in a Jumbo mode chassis, you can also congure the mtu and ip mtu commands. The Link MTU
and IP MTU values congured on the channel members must be greater than the Link MTU and IP MTU values
congured on the Port Channel interface.
If the stack—unit card is in a Jumbo mode chassis, you can also congure the mtu and ip mtu commands. The
Link MTU and IP MTU values congured on the channel members must be greater than the Link MTU and IP MTU
values congured on the Port Channel interface.
NOTE: In a Jumbo-enabled system, all members of a Port Channel must be congured with the same
link MTU values and the same IP MTU values.
Example
Dell(conf)# int port-channel 2
Dell(conf-if-po-2)#
Related Commands
• channel-member — add a physical interface to the LAG.
• interface — congure a physical interface.
• interface loopback — congure a Loopback interface.
• interface null — congure a null interface.
• interface vlan — congure a VLAN.
• shutdown — disable/enable the port channel.
minimum-links
Congure the minimum number of links in a LAG (Port Channel) that must be in “oper up” status for the LAG to be also in “oper up” status.
Syntax
minimum-links number
Parameters
number Enter the number of links in a LAG that must be in “oper up” status. The range is from 1 to
16. The default is 1.
Defaults 1
Command Modes INTERFACE
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
698 Interfaces