Users Guide

Field Description
• L1 = IS-IS level-1
• L2 = IS-IS level-2
• IA = IS-IS inter-area
• * = candidate default
• > = non-active route
• + = summary routes
The weight for weighted ECMP route calculations is displayed for each path in the route
in show ip route command. The ECMP weight is displayed only if weighted ECMP is
enabled using the ip ecmp weighted command is enabled.
If weighted ECMP is disabled, the show ip route command does not show the
weighted ECMP route information.
Destination Identies the route’s destination IP address
Gateway Identies whether the route is directly connected and on which interface the route is
congured.
Dist/Metric Identies if the route has a specied distance or metric.
Last Change Identies when the route was last changed or congured.
Example
Dell# show ip route all
Codes:C- connected, S - static, R - RIP
B- BGP, IN - internal BGP, EX - external BGP, LO - Locally Originated
O- OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1
N2- OSPF NSSA external type 2, E1 - OSPF external type 1
E2- OSPF external type 2, i - IS-IS, L1 - IS-IS level-1
L2- IS-IS level-2, IA - IS-IS inter area, * - candidate default
>- non-active route + - summary route
Gateway of last resort is not set
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
R 3.0.0.0/8 via 100.10.10.10, Te 1/1/8/1 120/1 00:07:12
via 101.10.10.10, Te 1/1/8/2
100.10.10.0/24 Direct, Te 1/1/8/1 0/0 00:08:54
> R 100.10.10.0/24 Direct, Te 1/1/8/2 120/0 00:08:54
C 101.10.10.0/24 Direct, Te 1/1/8/1 0/0 00:09:15
> R 101.10.10.0/24 Direct, Te 1/1/8/2 120/0 00:09:15
Dell#
Example (Summary)
Dell# show ip route summary
Route Source Active Routes Non-active Routes
connected 2 0
static 1 0
Total 3 0
Total 3 active route(s) using 612 bytes
R1_E600i>show ip route static ?
| Pipe through a command
<cr>
R1_E600i>show ip route static
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
*S 0.0.0.0/0 via 10.10.91.9, Te 1/1/2/1 1/0 3d2h
Dell>
768 IPv4 Routing