Users Guide

Version Description
9.7(0.0) Introduced on the S6000-ON.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.7.0 Introduced on the S4810.
8.4.2.1 Introduced on the S-Series.
8.4.2.0 Introduced on the E-Series.
7.8.1.0 Introduced on the C-Series.
Example
Example (Manual
Proles)
Dell# show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 4
Ipv4Qos : 2
L2Qos : 3
-- Line card 4 --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 4
Ipv4Qos : 2
L2Qos : 3
Dell#
Related Commands
• cam-acl — congure CAM proles to support IPv6 ACLs.
permit icmp
To allow all or specic internet control message protocol (ICMP) messages, congure a lter.
Syntax
To remove this lter, you have two choices:
• Use the no seq sequence-number command if you know the lter’s sequence number.
• Use the no permit icmp {source address mask | any | host ipv6-address}
{
destination address | any | host ipv6-address} command.
Parameters
Defaults Not congured.
Command Modes ACCESS-LIST
790 IPv6 Access Control Lists (IPv6 ACLs)