Users Guide

• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
•
For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults Not congured.
Command Modes CONFIGURATION
Command History
This guide is platform-specic. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version Description
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.5(0.1) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.5.1.0 Added support for 4-port 40G line cards on the E-Series.
6.2.1.1 Introduced
ip msdp peer
Congure an MSDP peer.
Syntax
ip msdp peer peer address [connect-source] [description] [sa-limit number]
To remove the MSDP peer, use the no ip msdp peer peer address [connect-source interface]
[description name] [sa-limit number] command.
Parameters
peer address Enter the peer address in a dotted decimal format (A.B.C.D.).
connect-source
interface
Enter the keywords connect-source then one of the interfaces and slot/port or
number information:
954 Multicast Source Discovery Protocol (MSDP)