Users Guide

which the sequence numbers were assigned by the software. The lters were assigned sequence numbers based on the order in which
they were congured (for example, the rst lter was given the lowest sequence number). The show config command in IP ACCESS
LIST mode displays the two lters with the sequence numbers 5 and 10.
Example of Viewing Filter Sequence for a Specied Extended ACL
Dell(config-ext-nacl)#deny tcp host 123.55.34.0 any
Dell(config-ext-nacl)#permit udp 154.44.123.34 0.0.255.255 host 34.6.0.0 monitor 111
Dell(config-ext-nacl)#show config
!
ip access-list extended nimule
seq 5 deny tcp host 123.55.34.0 any
seq 10 permit udp 154.44.0.0 0.0.255.255 host 34.6.0.0 monitor 111
Dell(config-ext-nacl)#
To view all congured IP ACLs and the number of packets processed through the ACL, use the show ip accounting access-list
command in EXEC Privilege mode, as shown in the rst example in Congure a Standard IP ACL Filter.
Congure Layer 2 and Layer 3 ACLs
Both Layer 2 and Layer 3 ACLs may be congured on an interface in Layer 2 mode.
If both L2 and L3 ACLs are applied to an interface, the following rules apply:
• When Dell Networking OS routes the packets, only the L3 ACL governs them because they are not ltered against an L2 ACL.
• When Dell Networking OS switches the packets, rst the L3 ACL lters them, then the L2 ACL lters them.
• When Dell Networking OS switches the packets, the egress L3 ACL lters the packet.
For the following features, if you enable counters on rules that have already been congured and a new rule is either inserted or prepended,
all the existing counters are reset:
• L2 ingress access list
• L3 egress access list
• L2 egress access list
If a rule is simply appended, existing counters are not aected.
Table 6. L2 and L3 Filtering on Switched Packets
L2 ACL Behavior L3 ACL Behavior Decision on Targeted Trac
Deny Deny L3 ACL denies.
Deny Permit L3 ACL permits.
Permit Deny L3 ACL denies.
Permit Permit L3 ACL permits.
NOTE: If you congure an interface as a vlan-stack access port, only the L2 ACL lters the packets. The L3 ACL applied to such
a port does not aect trac. That is, existing rules for other features (such as trace-list, policy-based routing [PBR], and QoS)
are applied to the permitted trac.
For information about MAC ACLs, refer to Layer 2.
Assign an IP ACL to an Interface
To pass trac through a congured IP ACL, assign that ACL to a physical interface, a port channel interface, or a VLAN.
The IP ACL is applied to all trac entering a physical or port channel interface and the trac is either forwarded or dropped depending on
the criteria and actions specied in the ACL.
118
Access Control Lists (ACLs)