Users Guide

Pluggable media not present
Interface index is 46449666
Internet address is 10.11.131.240/23
[output omitted]
Dell#show ip route
Codes: C - connected, S - static, R - RIP,
B - BGP, IN - internal BGP, EX - external BGP,LO - Locally Originated,
O - OSPF, IA - OSPF inter area, N1 - OSPF NSSA external type 1,
N2 - OSPF NSSA external type 2, E1 - OSPF external type 1,
E2 - OSPF external type 2, i - IS-IS, L1 - IS-IS level-1,
L2 - IS-IS level-2, IA - IS-IS inter area, * - candidate default,
> - non-active route, + - summary route
Gateway of last resort is 10.11.131.254 to network 0.0.0.0
Destination Gateway Dist/Metric Last Change
----------- ------- ----------- -----------
*S 0.0.0.0/0 via 10.11.131.254, Te 1/1/1/1 1/0 1d2h
C 10.11.130.0/23 Direct, Te 1/1/1/1 0/0 1d2h
Dell#
VLAN Interfaces
VLANs are logical interfaces and are, by default, in Layer 2 mode. Physical interfaces and port channels can be members of VLANs.
For more information about VLANs and Layer 2, see Layer 2 and Virtual LANs (VLANs).
NOTE: To monitor VLAN interfaces, use Management Information Base for Network Management of TCP/IP-based internets:
MIB-II (RFC 1213).
NOTE: You cannot simultaneously use egress rate shaping and ingress rate policing on the same VLAN.
Dell Networking OS supports Inter-VLAN routing (Layer 3 routing in VLANs). You can add IP addresses to VLANs and use them in routing
protocols in the same manner that physical interfaces are used. For more information about conguring dierent routing protocols, refer to
the chapters on the specic protocol.
A consideration for including VLANs in routing protocols is that you must congure the no shutdown command. (For routing trac to
ow, you must enable the VLAN.)
NOTE
: You cannot assign an IP address to the default VLAN, which is VLAN 1 (by default). To assign another VLAN ID to the
default VLAN, use the default vlan-id vlan-id command.
To assign an IP address to an interface, use the following command.
• Congure an IP address and mask on the interface.
INTERFACE mode
ip address ip-address mask [secondary]
• ip-address mask: enter an address in dotted-decimal format (A.B.C.D). The mask must be in slash format (/24).
• secondary: the IP address is the interface’s backup IP address. You can congure up to eight secondary IP addresses.
Example of a Conguration for a VLAN Participating in an OSPF Process
interface Vlan 10
ip address 1.1.1.2/24
tagged TenGigabitEthernet 1/1/2/1-1/1/4/4
tagged TenGigabitEthernet 5/1/1
ip ospf authentication-key force10
ip ospf cost 1
ip ospf dead-interval 60
ip ospf hello-interval 15
no shutdown
!
Interfaces
365