Users Guide

[Use the command on the remote system that is equivalent to the rst command.]
3 Access CONFIGURATION mode.
EXEC Privilege mode
config
4 Access the port.
CONFIGURATION mode
interface interface-type
5 Set the local port speed.
INTERFACE mode
speed {10 | 100 | 1000 | 10000 | auto}
NOTE: If you use an active optical cable (AOC), you can convert the QSFP+ port to a 10 Gigabit SFP+ port or 1 Gigabit
SFP port. You can use the speed command to enable the required speed.
6 Optionally, set full- or half-duplex.
INTERFACE mode
duplex {half | full}
7 Disable auto-negotiation on the port.
INTERFACE mode
no negotiation auto
If the speed was set to 1000, do not disable auto-negotiation.
8 Verify conguration changes.
INTERFACE mode
show config
Example of the show interfaces status Command to View Link Status
NOTE
: The show interfaces status command displays link status, but not administrative status. For both link and
administrative status, use the show ip interface command.
Dell#show interfaces status
Port Description Status Speed Duplex Vlan
Te 1/1/1 Down Auto Mbit Auto --
Te 1/1/2 Down 10000 Mbit Auto --
Te 1/1/3 Down Auto Mbit Auto --
Te 1/1/4 Down 10000 Mbit Auto --
Te 1/2/1 Up 10000 Mbit Full 2-5
Te 1/2/2 Up 10000 Mbit Full 2-5
Te 1/2/3 Up Auto Mbit Full 2-5
Te 1/2/4 Up 10000 Mbit Full 2-5
Fo 1/3 Down 40000 Mbit Auto --
Fo 1/4 Down 40000 Mbit Auto --
Fo 1/5 Down Auto Mbit Auto --
[output omitted]
In the previous example, several ports display “Auto” in the Speed eld. In the following example, the speed of port 1/1 is set to 100Mb and
then its auto-negotiation is disabled.
Dell#configure
Dell(config)#interface tengig 1/1/1/1
Dell(conf-if-te-1/1/1/1)#speed 100
Dell(conf-if-te-1/1/1/1)#duplex full
Dell(conf-if-te-1/1/1/1)#no negotiation auto
Dell(conf-if-te-1/1/1/1)#show config
388
Interfaces