Users Guide

The following example shows viewing the default buer prole on an interface.
Dell#show buffer-profile detail interface tengigabitethernet 1/1/1/1
Interface Te 1/1/1/1
Buffer-profile fsqueue-fp
Dynamic buffer 1256.00 (Kilobytes)
Queue# Dedicated Buffer Buffer Packets
Kilobytes)
0 3.00 256
1 3.00 256
2 3.00 256
3 3.00 256
4 3.00 256
5 3.00 256
6 3.00 256
7 3.00 256
The following example shows viewing the default buer prole on a linecard.
Dell#sho buffer-profile detail fp-uplink stack-unit 1 port-set 0
Stack Unit 1 Port-set 0
Buffer-profile fsqueue-hig
Dynamic Buffer 1256.00 (Kilobytes)
Queue# Dedicated Buffer Buffer Packets
(Kilobytes)
0 3.00 256
1 3.00 256
2 3.00 256
3 3.00 256
4 3.00 256
5 3.00 256
6 3.00 256
7 3.00 256
Using a Pre-Dened Buer Prole
Dell Networking OS provides two predened buer proles, one for single-queue (for example, non-quality-of-service [QoS]) applications,
and one for four-queue (for example, QoS) applications.
You must reload the system for the global buer prole to take eect, a message similar to the following displays: % Info: For the
global pre-defined buffer profile to take effect, please save the config and reload the system.
.
Dell Networking OS Behavior: After you congure buer-prole global 1Q, the message displays during every bootup. Only one reboot is
required for the conguration to take eect; afterward you may ignore this bootup message.
Dell Networking OS Behavior: If you congure 1Q, save the running-cong to the startup-config, and then delete the startup-
config
and reload the chassis. The only way to return to the default buer prole is to remove the 1Q prole congured and then reload
the chassis.
If you have already applied a custom buer prole on an interface, the buffer-profile global command fails and a message similar
to the following displays:
% Error: User-defined buffer profile already applied. Failed to apply global
pre-defined buffer profile. Please remove all user-defined buffer profiles.
Similarly, when you congure buffer-profile global, you cannot not apply a buer prole on any single interface. A message similar
to the following displays:
% Error: Global pre-defined buffer profile already applied. Failed to apply
user-defined buffer profile on interface Te 1/1. Please remove global pre-defined buffer
profile.
To apply a predened buer prole, use the following command:
• Apply one of the predened buer proles for all port pipes in the system.
CONFIGURATION mode
Debugging and Diagnostics
979