Administrator Guide

Te 1/1/1/3 (Up)
DellEMC#
Related
Commands
● show lacp — display the LACP matrix.
show port-channel-flow
Display an egress port in a given port-channel flow.
Syntax
show port-channel-flow outgoing-port-channel number incoming-interface
interface {source-ip address destination-ip address} | {source-port number
destination-port number} | {source-mac address destination-mac address
{vlan vlanid | ether-type}}
Parameters
outgoing-port-
channel number
Enter the keywords outgoing-port-channel then the number of the port
channel to display flow information.
● For a Port Channel interface, enter the keywords port-channel then a
number. The range is from 1 to 4096.
incoming-
interface
interface
Enter the keywords incoming-interface then the interface type and the
interface information:
● For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the stack/slot/port/subport information.
● For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE
then the stack/slot/port/subport information.
● For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the
stack/slot/port[/subport] information.
● For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the
stack/slot/port/subport information.
● For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then
the stack/slot/port information.
source-ip
address
Enter the keywords source-ip then the IP source address in IP address format.
destination-ip
address
Enter the keywords destination-ip then the IP destination address in IP
address format.
source-port
number
Enter the keywords source-port then the source port number. The range is
from 1 to 65536. The default is None.
destination-port
number
Enter the keywords destination-port then the destination port number. The
range is from 1 to 65536. The default is None.
source-mac
address
Enter the keywords source-mac then the MAC source address in the
nn:nn:nn:nn:nn:nn format.
destination-mac
address
Enter the keywords destination-mac then the MAC destination address in the
nn:nn:nn:nn:nn:nn format.
vlan vlan-id Enter the keywords vlan then the VLAN-id. The range is from 0 to 4094.
ether-type Enter the keywords ether-type in the XX:XX format.
Command Modes EXEC
Command
History
This guide is platform-specific. For command information about other platforms, see the relevant Dell
EMC Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
Interfaces 729