Users Guide
Router C without immediately updating Router C’s conguration. Local-AS allows this behavior to happen by allowing Router B to appear as
if it still belongs to Router B’s old network (AS 200) as far as communicating with Router C is concerned.
Figure 25. Before and After AS Number Migration with Local-AS Enabled
When you complete your migration, and you have recongured your network with the new information, disable this feature.
If you use the “no prepend” option, the Local-AS does not prepend to the updates received from the eBGP peer. If you do not select “no
prepend” (the default), the Local-AS is added to the rst AS segment in the AS-PATH. If an inbound route-map is used to prepend the as-
path to the update from the peer, the Local-AS is added rst. For example, consider the topology described in the previous illustration. If
Router B has an inbound route-map applied on Router C to prepend "65001 65002" to the as-path, the following events take place on
Router B:
1 Receive and validate the update.
2 Prepend local-as 200 to as-path.
3 Prepend "65001 65002" to as-path.
Local-AS is prepended before the route-map to give an impression that update passed through a router in AS 200 before it reached Router
B.
BGP4 Management Information Base (MIB)
The FORCE10-BGP4-V2-MIB enhances support for BGP management information base (MIB) with many new simple network
management protocol (SNMP) objects and notications (traps) dened in draft-ietf-idr-bgp4-mibv2-05. To see these enhancements,
download the MIB from the Dell website.
NOTE
: For the
Force10-BGP4-V2-MIB
and other MIB documentation, refer to the Dell iSupport web page.
Important Points to Remember
• Because eBGP packets are not controlled by the ACL, packets from BGP neighbors cannot be blocked using the deny ip command.
Border Gateway Protocol (BGP)
197