Users Guide

• On the system that telnets into the switch, this message appears:
% Warning: The following users are currently configuring the system:
User "<username>" on line console0
• On the system that is connected over the console, this message appears:
% Warning: User "<username>" on line vty0 "10.11.130.2" is in configuration mode
If either of these messages appears, Dell EMC Networking recommends coordinating with the users listed in the message so that you do
not unintentionally overwrite each other’s conguration changes.
Conguring alias command
You can congure shorter alias names for single–line command input using the alias command.
To congure the alias name, perform the following steps:
1 Congure the terminal to enter the Global Conguration mode.
EXEC Privilege mode
DellEMC#configure terminal
2 Congure the system to enter the alias-denition mode.
CONFIGURATION mode
DellEMC(conf)#alias-definition
3 Create the alias name followed by the single–line CLI.
ALIAS DEFINITION CONFIGURATION mode
DellEMC(conf-alias-definition)#alias sr show running-config
4 Display the aliases and its denition.
EXEC Privilege mode
show alias
Example of the show alias Command
DellEMC# configure terminal
DellEMC(config)# alias-definition
DellEMC(conf-alias-definition)# alias ns no shutdown
DellEMC(conf-alias-definition)# alias 10gint interface TenGigabitEthernet $1
Viewing alias conguration
To view the Alias congurations, use the following commands:
1 Display the complete list of aliases and its denitions.
EXEC Privilege mode
DellEMC#show alias
DellEMC# show alias
-----------------------------------------------------------------
Alias Name Definition
-----------------------------------------------------------------
showipbr10 show ip interface brief | ….
showipbr40 show ip interface brief | ….
shboot show bootvar…
cr-vlan interface vlan $1 ..
Conguration
Fundamentals 47