Users Guide

Figure 113. Packet Drop Rate for WRED
You can create a custom WRED prole or use one of the ve pre-dened proles.
Enabling and Disabling WRED Globally
By default, WRED is enabled on the system. You can disable or reenable WRED manually using a single command. Follow these steps to
disable or enable WRED in Dell EMC Networking OS.
• Enable WRED
CONFIGURATION mode
wred enable
• Disable WRED
CONFIGURATION mode
no wred enable
NOTE
: If you disable WRED globally, the system accepts any WRED prole you apply to trac. But the changes do not take
eect until you enable WRED globally.
Creating WRED Proles
To create WRED proles, use the following commands.
1 Create a WRED prole.
CONFIGURATION mode
wred-profile
2 Specify the minimum and maximum threshold values.
WRED mode
threshold
768
Quality of Service (QoS)