Administrator Guide

• track interface ipv6 routing – configure object tracking on the routing status of an IPv6 Layer 3 interface.
• track ipv6 route metric threshold – configure object tracking on the threshold of an IPv6 route metric.
• track ipv6 route reachability – configure object tracking on the reachability of an IPv6 route.
track interface ipv6 routing
Configure object tracking on the routing status of an IPv6 Layer 3 interface.
Syntax
track object-id interface interface ipv6 routing
To return to the default setting, use the no track object-id command.
Parameters
object-id Enter the ID number of the tracked object. The range is 1 to 500.
interface Enter one of the following values:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
•
For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a tunnel interface, enter the keyword tunnel.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
9.10(0.0) Introduced on the S6100-ON.
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100-ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
8.3.12.0 Introduced on the S4810.
8.4.1.0 Introduced.
Usage Information Use this command to create an object that tracks the routing state of an IPv6 Layer 3 interface:
• The status of the IPv6 interface is UP only if the Layer 2 status of the interface is UP and the interface has a
valid IP address.
• The Layer 3 status of an IPv6 interface goes DOWN when its Layer 2 status goes down (for a Layer 3 VLAN,
all VLAN ports must be down) or the IP address is removed from the routing table.
1010 Object Tracking