Administrator Guide

• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a Tunnel interface, enter the keyword tunnel then a number from 1 to 16383.
tos (IPv4 only) Enter the type of service required. The range is from 0 to 255. The default is
0.
df-bit (IPv4 only) Enter Y or N for the “don't fragment” bit in IPv4 header.
• N: Do not set the “don't fragment” bit.
• Y: Do set “don't fragment” bit
Default is No.
validate-reply (IPv4 only) Enter Y or N for reply validation.
• N: Do not validate reply data.
• Y: Do validate reply data.
Default is No.
outgoing-interface (IPv6 link-local address) Enter the outgoing interface for ping packets to a destination
link-local address.
pattern pattern (IPv4 only) Enter the IPv4 data pattern. Range: 0-FFFF. Default: 0xABCD.
sweep-min-size Enter the minimum size of datagram in sweep range. The range is from 52 to 15359
bytes.
sweep-max-size Enter the maximum size of datagram in sweep range. The range is from 53 to 15359
bytes.
sweep-interval Enter the incremental value for sweep size. The range is from 1 to 15308 seconds.
interface (IPv4 only) Enter the outgoing interface for multicast packets. Enter the IP address in
A.B.C.D format.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
ethernet Enter the keyword ethernet to test layer2 connectivity.
vrf vrf-name Enter the keyword vrf followed by the name of the VRF to test connectivity to the VRF.
Defaults None.
Command Modes
• EXEC
• EXEC Privilege
Control and Monitoring 113