Administrator Guide

Version Description
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Added the kbps option on the C-Series, E-Series, and S-Series.
7.6.1.0 Introduced on the S-Series and C-Series.
6.1.1.1 Introduced on the E-Series.
Usage Information
If traffic is shaped between 64 and 1000 Kbs, for some values, the shaped rate is much less than the value
configured.
On 40-port 10G stack-unit if the traffic is shaped between 64 and 1000 Kbs, for some values, the shaped rate is
much less than the value configured.
NOTE: When packets of size greater than 7000 bytes are expected to be received from the
network, Dell EMC Networking recommends that you configure the burst value to be more than
175 KB if you configured the rate shape. Such a setting ensures proper bandwidth sharing across
queues.
Related
Commands
• rate-shape — shapes traffic output as part of the designated policy.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all interfaces (from
CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE mode entry.
Syntax
service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class dynamic dot1p command.
The default mapping is as follows:
dot1p Queue ID
0 1
1 0
2 2
3 3
4 4
5 5
6 6
7 7
Command Modes
• INTERFACE
• CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
1202 Quality of Service (QoS)