Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S6100-ON

1621

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then

the stack/slot/port/subport information.

• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the

stack/slot/port/subport information.

• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/

slot/port[/subport] information.

• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/

slot/port/subport information.

• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the

stack/slot/port information.

• For a Port Channel, enter the keywords port-channel.

VLAN-ID

Enter the VLAN ID.

Defaults Disabled

Command Modes

• EXEC

• EXEC Privilege

Command History

This guide is platform-specific. For command information about other platforms, refer to the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.11(0.0) Introduced on the S4048–ON, S4048T-ON, S6000–ON, S6010–ON, S6100–ON, and

Z9100–ON.

Example

DellEMC#show vxlan vxlan-instance 1 statistics interface fortyGigE 1/4/1 100

Port : Fo 1/4/1 Vlan : 100

Rx Packets : 13

Rx Bytes : 1317

Tx Packets : 13

Tx Bytes : 1321

Commands

vxlan-instance- Enable VXLAN Instance configuration on the platform.

show vxlan vxlan-instance statistics remote-vtep-

Displays VXLAN statistics for a specific VXLAN tunnel.

Syntax

show vxlan vxlan-instance instance ID statistics remote-vtep-ip IP Address

Parameters

instance ID

Enter the VXLAN instance ID. The platform supports only the instance ID 1 in the initial

release.

remote-vtep-ip Enter the keyword remote-vtep-ip followed by the IP Address of the remote VTEP.