Administrator Guide

Version Description
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Introduced on the E-Series.
Usage Information
When all sequence numbers are exhausted, this feature permits re-assigning a new sequence number to entries of
an existing access-list.
seq
Assign a sequence number to a deny or permit filter in an extended IP access list while creating the filter.
Syntax
seq sequence-number {deny | permit} {ip-protocol-number | icmp | ip | tcp |
udp} {source mask | any | host ip-address} {destination mask | any | host ip-
address} [operator [portnumber | portname]] [ttl operator] [count [byte] | log]
[dscp value] [ecn value] [fragments] [monitor [session-ID]] [no-drop] [order]
Parameters
sequence-number Enter a number from 0 to 4294967290.
deny Enter the keyword deny to configure a filter to drop packets meeting this condition.
permit Enter the keyword permit to configure a filter to forward packets meeting this criteria.
ip-protocol-
number
Enter a number from 0 to 255 to filter based on the protocol identified in the IP protocol
header.
icmp Enter the keyword icmp to configure an ICMP access list filter.
ip Enter the keyword ip to configure a generic IP access list. The keyword ip specifies that
the access list permits all IP protocols.
tcp Enter the keyword tcp to configure a TCP access list filter.
udp Enter the keyword udp to configure a UDP access list filter.
source Enter an IP address in dotted decimal format of the network from which the packet was
received.
mask (OPTIONAL) Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when
specified in A.B.C.D format, may be either contiguous or non-contiguous.
any Enter the keyword any to specify that all routes are subject to the filter.
host ip-address Enter the keyword host and then enter the IP address to specify a host IP address or
hostname.
operator (OPTIONAL) Enter one of the following logical operands:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports for the port
parameter.)
portnumber (OPTIONAL) Enter the application layer port number. Enter two port numbers if you are
using the range logical operand. The range is from 0 to 65535.
The following list includes some common TCP port numbers:
• 23 = Telnet
• 20 and 21 = FTP-DATA and FTP
• 25 = SMTP
• 169 = SNMP
portname (OPTIONAL) Enter the logical name of the protocol.
214 Access Control Lists (ACL)