Administrator Guide

NOTE: The protocols that are not mapped to the CPU queues are mapped to Queue 0.
Example
DellEMC(conf)#control-plane-cpuqos
DellEMC(conf-control-cpuqos)#copp-policy COPP
DellEMC(conf-control-cpuqos)#show config
!
control-plane-cpuqos
copp-policy COPP
DellEMC(conf-control-cpuqos)#
protocol-list
Creates a protocol list to be configured under a protocol group.
Syntax
protocol-list protocol-name1, protocol-name2,.....
Use the no protocol-list command to remove the protocols from the protocol-group.
Command Modes CPU-PROTOCOL-GROUP
Parameters
protocol-name1,
protocol-
name2, ...
Enter the list of protocols to be associated with the protocol group.
NOTE: When you specify multiple protocols to be associated with a protocol-
group profile, you must de-limit each protocol name with only a coma.
Command History
Version Description
9.11.0.0 Introduced on the S6000, S6000–ON, Z9100–ON, and S6100–ON.
Usage Information
When a new set of protocols is configured in the protocol-group over an existing set of protocols, the new set
replaces the existing list of protocols in the protocol-group.
Example
DellEMC#configure terminal
DellEMC(conf)#cpu-protocol-group PG0
DellEMC(conf-cpu-protocol-group)#protocol-list 802dot1x , arp-req , arp-rsp
DellEMC(conf-cpu-protocol-group)#show config
!
cpu-protocol-group PG0
protocol-list 802dot1x , arp-req , arp-rsp
DellEMC(conf-cpu-protocol-group)#
queue-length
Configures queue length.
Syntax
queue—length queue-length-value
Use the no queue-length command to remove the queue length configuration.
Command Modes QOS-POLICY-INPUT
Parameters
queue-length-
value
Enter the queue length value you want to configure. The range is from 0 to 235.
Default The default value is 235.
Command History
Version Description
9.11.0.0 Introduced on the S6000, S6000–ON, Z9100–ON, and S6100–ON.
Usage Information
The queue-length takes effect only if the qos-policy is associated with a copp-policy.
Control Plane Policing (CoPP) 453