Administrator Guide
Version Description
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
7.4.1.0 Modified for E-Series: Revised from 78 to 240 characters.
Usage Information
Important Points to Remember:
• To use special characters as a part of the description string, you must enclose the whole string in double
quotes.
• Spaces between characters are not preserved after entering this command unless you enclose the entire
description in quotation marks (“desc_text”).
• Entering a text string after the description command overwrites any previous text string that you
previously configured as the description.
• The shutdown and description commands are the only commands that you can configure on an
interface that is a member of a port-channel.
• Use the show interfaces description command to display descriptions configured for each
interface.
default interface
Reset a physical interface to its factory default settings.
Syntax
default interface interface-type slot/port - range
Parameters
interface-type
slot/port
[
/
subport
]
Enter the interface type and slot/port [/subport] information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the slot/
port/subport information.
•
For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
slot/port/subport information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the slot/
port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
slot/port/subport information.
range
• For non-ON platforms, you can specify multiple ports as slot/port-range. For
example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1 - 4.
• For ON platforms, you can specify multiple ports as slot/port/[subport] -
slot/port/[subport]. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show
interfaces interface-type 1/1/1 - 1/1/4.
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S3148.
636 Interfaces