Administrator Guide
Version Description
8.3.11.1 Introduced on the Z9000.
8.3.11.1 Introduced on the S55, S60, and S4810
8.1.1.0 Introduced on the E-Series.
7.5.1.0 Introduced on the C-Series.
pre-Version
6.2.1.0
Introduced on the E-Series.
Usage Information This command is found on the Management interface only.
Related
Commands
• interface ManagementEthernet — configure the Management port on the system (either the Primary or
Standby RPM).
• management route — configure a static route that points to the Management interface or a forwarding
router.
stack-unit portmode
Convert a single 40G port into 4x10G ports in a 16x40G module and a single 100G port into 2x50G ports, 1x40G port, 4x25G ports or
4x10G ports in an 8x100G module.
Syntax
stack-unit stack-unit-number module module-number port number portmode {dual
speed 50G | quad speed {25G | 10G} | single speed 40G} [no-confirm]
Parameters
stack-unit
Enter the stack member unit identifier of the stack member to reset.
module Enter the keyword module then the module number to specify the optional module
where the port is present.
port Enter the keyword port then the port number to specify the port where fanout mode is
specified.
single Convert a single 100G port into one 40G port.
dual Split a single 100G port into two 50G ports.
quad Split a single 100G port into four 10G or four 25G ports or split a single 40G port into four
10G ports
no-confirm (OPTIONAL) Enter the keywords no-confirm to reset any previous configuration and
apply the new configuration immediately. If you this option, the system does not prompt
you to confirm the deletion of any existing configuration.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC
Networking OS Command Line Reference Guide.
Version Description
9.10(0.1) Introduced on the S6010-ON and S4048T-ON.
9.10(0.0) Introduced on the S6100–ON.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.7(0.0) Added support for dynamically fanning-out of interfaces on S6000. Introduced on the
S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
692 Interfaces