Administrator Guide

ManualsBrandsDell ManualsAccess PlatformsPowerSwitch S6100-ON

701

702

703

704

705

706

707

708

709

710

• show ip management-route

• show ipv6 management-route

• show ip protocols

• show ip route

• show ip route list

• show ip route summary

• show ip traffic

• show tcp statistics

arp

To associate an IP address with a MAC address in the switch, use address resolution protocol (ARP).

Syntax

arp [vrf vrf-name] ip-address mac-address interface

To remove an ARP address, use the no arp ip-address command.

Parameters

vrf

vrf-name

Enter a VRF name to configure an ARP entry for that VRF. Use the VRF option after the

keyword arp to configure a static arp on that particular VRF.

ip-address

Enter an IP address in dotted decimal format.

mac-address

Enter a MAC address in nnnn.nnnn.nnnn format.

interface

Enter any of the following keywords and the interface information:

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then

the stack/slot/port/subport information.

• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the

stack/slot/port/subport information.

•

For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/

slot/port[/subport] information.

• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/

slot/port/subport information.

• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the

stack/slot/port information.

• For the Management interface on the stack-unit, enter the keyword

ManagementEthernet then the slot/port information.

• For a port channel interface, enter the keywords port-channel then a number.

Defaults Not configured.

Command Modes CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell EMC

Networking OS Command Line Reference Guide.

Version Description

9.10(0.1) Introduced on the S6010-ON and S4048T-ON.

9.10(0.0) Introduced on the S3148.

9.10(0.0) Introduced on the S6100–ON.

9.8(2.0) Introduced on the S3100 series.

9.8(1.0) Introduced on the Z9100–ON.

9.8(0.0P5) Introduced on the S4048-ON.

9.8(0.0P2) Introduced on the S3048-ON.

9.7(0.0) Introduced on the S6000-ON.

9.4(0.0) Added support for VRF.

9.2(1.0) Introduced on the Z9500.

IPv4 Routing 707