Install Guide

4 Plug in the appropriate AC three prongs power cord from the switch PSU to the external power source.
5 Repeat steps 1 through 4 above using the second PSU slot on the S6100-ON system.
NOTE: The S6100-ON powers up when the cables are connected between the power supply and the power source.
DC power supply connection
Each DC powered system comes with a set containing a prewired, 3-inch 8 AWG, power supply connector and a four-screw wiring block.
One set is provided for each DC PSU.
Figure 26. DC power connector and wiring block
1
DC wire RTN 2 DC power connector
3 Two Captive screws 4 Release tab
5 PSU status LED 6 DC power socket
7 DC wire –48V
34 Power supplies