Setup Guide

Figure 3. Cable Connector

1. Two-hold cable connector high-strand-count conductor

2. Two-holes for cable (.27 ±.02 DIA)

Installing an I/O Module

To install an I/O module, follow these steps.

WARNING: Install a blank panel in any unused switch I/O slot.

NOTE: The S6100-ON has capacitors located on the front-left corner of

the PC board. To avoid damaging these capacitors when installing an

I/O module, align the I/O module with the yellow arrows located inside

the chassis and then gently slide the I/O module in place.

NOTE: If you remove and re-insert a module in the same slot, the

system detects the module. However, if you remove a module from a

slot and insert a different module into that same slot, the system does

not detect the new module.

NOTE: Module power is software controlled. You will not see module

LEDs when the system powers up in the Open Network Installation

Environment (ONIE).

1. Remove the I/O module from the electro-static bag.

2. Open the left ejector lever (item 1) by pressing in the orange tab (item 2)

and rotating it to the right so that the level snaps into the open position.

3. Slide the I/O module into the switch I/O slot.

Install the Hardware