Setup Guide

The slot is keyed so that the I/O module fully inserts in only one way.

When you install the I/O module correctly, it snaps into place and is flush

with the back of the switch.

Figure 4. Installing an I/O Module

1. Ejector lever 2. Orange release tab

3. I/O Module

Important Points to Remember

The S6100–ON is designed to support two hot-swappable power supplies

with integrated fans that provide cooling for the chassis.

• The S6100–ON ships with two power supplies.

• The PSU slides into the slot smoothly. Do not force the PSU into a slot as

this action may damage the PSU or the S6100-ON chassis.

• The S6100–ON supports AC and DC power supplies with two air-flow

directions (I/O to Utility and Utility to I/O). The S6100–ON does not

support mixing PSU types. The fan airflow direction for the PSUs must be

the same.

• Module power is software controlled. You do not see module LEDs when

the system powers up.

Install the Hardware