Setup Guide

Figure 8. DC Power Connector Ground

1. Ground nut 2. Washer

3. Lock washer 4. Ground cable

5. Device grounding rod

To connect a DC PSU to the site’s DC power source, follow these steps:

1. Strip 1/2 inches of insulation from each of the power connector’s wires,

as shown.

2. Insert each of the power connector’s bare wire lengths into the wiring

block, as shown.

3. Use a flat-blade screwdriver to tighten the screws that secures the bare

wires into the wiring block.

4. Secure the site’s DC power source wires to the other side of the wiring

block (See steps 1 and 3).

5. Insert the DC power connector into the power socket of the DC PSU.

Ensure that the connector pins firmly seat and you hear the click of the

power connector’s left and right levered clamps lock into place.

WARNING: Never try to force the power connector into or out of

the DC PSU power socket.

Install the Hardware