Setup Guide

NOTE: To remove the power connector from a DC PSU, squeeze the

levers on both sides of the connector. Doing so disengages the power

connector’s clamps. While continuing to squeeze, pull the power

connector from the DC PSU socket.

Installing a Fan Module

CAUTION: DO NOT mix airflow directions. All fans must use the same

airflow direction (I/O to Utility or Utility to I/O).

CAUTION: Check the fans at six-month intervals and replace them as

necessary. To accurately determine replacement intervals, regularly

monitor the speeds of the cooling fans.

1. Remove the fan module from the shipping box.

2. Use the grab handle and the orange tab to slide the module into the

switch fan slot.

Figure 9. Install the Fan Module

1. Fan module 2. Release tab

Install the Hardware