Setup Guide

• Bring all unplated surfaces on your system to a bright finish and treat them

with an anti-oxidant solution before making connections.

• Remove any non-conductive surfaces on your system from the threads

and connection points to ensure electrical continuity.

• Use the two-hole, Listed, compression-type lug with a AWG 14 gauge wire

to secure your system to the frame.

NOTE: The S6100–ON can operate at -48 to -60 VDC at a maximum

current level of 24A.

NOTE: The S6100-ON is Earthquake Z4-compliant when you attach the

ReadyRails to the frame using threaded hardware.

NEBs Compliance